iPhone SE (3rd gen) — 326 ppi, 320 dpi (xhdpi)
iPhone SE (3rd gen) is a Apple device whose display works out to roughly 326 dpi, which Android classifies as the xhdpi bucket. Everything below is derived from the panel's physical resolution and diagonal size, so you can reproduce the numbers with a calculator and a spec sheet.
| Brand | Apple |
| Released | 2022 |
| Panel resolution | 750 × 1334 px |
| Diagonal | 4.7 in |
| Diagonal in pixels | 1,530 |
| Physical ppi | 325.6 |
| Density bucket | xhdpi (320 dpi) |
| Density source | Manufacturer's shipped density |
| Scale factor | 2.00× |
| 1 dp in px | 2.00 px |
| dp viewport | 375 × 667 dp |
| Aspect ratio (short:long) | 667:375 |
| Nearest bucket to ppi | 320 dpi |
Density on the iPhone SE (3rd gen)
At 326 dpi, one dp equals 2.04 physical pixels on this panel. That scale factor is what the system uses when it picks drawables from your mipmap folders and when it converts the layout values you wrote in dp into the pixels that actually get drawn.
What layout it actually gets
Because Android divides the physical resolution by the density scale, the layout does not see the full 326 dpi pixel grid — it sees a smaller box measured in dp. That is why two phones with very different resolutions can report the same dp width and lay out identically.
Practical notes
If you are designing for this device, author in dp and let the density scale handle the rest. If you are overriding density with wm density, remember that anything far from 326 dpi will make the UI look either oversized or cramped, because you are fighting the panel's native bucket.
Check another resolution
Want the numbers for a panel that is not in the database? The DPI calculator takes any width, height and diagonal.
Open the DPI calculatorOther Apple devices
Specifications last verified 2026-10-20. These are hardware values from the manufacturer's specification sheet; your device's reported density may differ if the ROM overrides it.